1-800-522-7274 AVAILABLE 24/7

Hablamos Español

Wilshire Law Firm Blog

Guide to Buying a Used Bike

used bicycle

Suggestions from Experienced Bicycle Accident Attorneys

Instead of going for that expensive new bike why not go for that affordable used one.  You will not only save lots of money, but you will also end up with a bike that is a much better brand than the one that you would get brand new for the same amount of money. However, buying a used bike is not that simple. Below are some useful tips to ensure that you are not getting cheated out of your money.

The first thing you ought to do when buying your bike is to ensure that it is indeed your size.  After ensuring that the bike fits you well, the next step is to inspect the used bike. Inspection is very crucial when buying a second-hand bike; it is actually the most important part of the transaction. You do not want to discover too late that you bought a bike with a cracked frame.

Your eyes, along with some knowledge, are all you need to conduct a thorough inspection on the bike. You need to pay particular attention to the following areas when inspecting the bicycle:

  1. Seat post: Ensure that the adjustable seat post is indeed working. Lift the bike a few inches and listen very closely when it drops. If you hear any rattling sound, then something is wrong. Additionally, use a flashlight to check if the area surrounding the clamp that supports the seat post is in place. This is a high-stress region, so there should be no holes at all in the material.
  2. Frame: Using a flashlight, inspect every single inch of the frame; it should have no crack. The tiniest crack could result in a big fall in case you ride over a pothole at the wrong speed.
  3. Frame attachments: This is inclusive of everything, from the rivets to the cable guides. If any part is badly rusted, request for permission to scrape at the corrosion, and if it is just some surface rust then all is well; there is no need to worry. Also, inspect the region between the smaller ring and the chain stay to check for a metal/plastic plate. If the plate is absent and there are some visible scratches, then that should be cause for suspicion.
  4. Steering assembly: Look into the technical specifications of the original brand (from the manufacturer’s website) and compare them to those of the bicycle that you are looking at. If you notice any significant differences, do not buy the bike.
  5. Wheels: Ensure that the wheels are in good condition. Look for rust around the spoke holes, check if the brake shoes are worn out, and also have a look at the rims.
  6. Cables: Inspect the quality of the brake cables at the spot where the cables move past the seat post to the rear wheel. This is one of the places where the cables get damaged. Also, check if the cables are in tension by squeezing the brakes and then suddenly releasing them. The lever ought to snap back almost immediately.
READ  Hit by a Car While Riding My Bike on the Sidewalk – What Now?

After carefully inspecting all the above parts, and ensuring that all is well, it is time for you to test drive the bike before buying it. You need to ensure that the bike is absolutely the right fit for you. Try riding it without your hands on the wheel to ensure that the wheels are true. Put the bike’s brake response to the test and try out some sharp turns to verify the overall balance of the bike. If satisfied, then you are ready to make your purchase.

With our experience as bicycle accident attorneys, we know how difficult it could be to get the perfect used bike. As one of the best bicycle accident attorneys, we advise that you carefully take your time to thoroughly inspect the used bike you are looking at before spending your money on it; do not rush into buying the bike.

Remember, if you sustain any injuries from an accident caused by a careless driver, contact our law firm and we will immediately assign to you one of our experienced bicycle accident attorneys to help in your case.

Posted in

Free Case Consultation

  • This field is for validation purposes and should be left unchanged.